Macally PHR-S250U3B Uživatelský manuál

IEEE 1394B FireWire/SuperSpeed USB3.02.5” Hard Drive EnclosurePHR-S250U3BUser’s Manual

Software InstallationSoftware Installation for MasOS X FireWire Connection for MasOS X When the enclosure is connected to the computer, MasOS X will

Software Installation for PCIEEE1394 FireWire Connection for WindowsXP/Vista/Windows7Plug the IEEE 1394 cable into any available port, WindowsXP/Vista

SATA HARD DRIVE PARTITION and FORMAT PROCEDURES in PC For WindowsXP/Vista/Windows 7If you can see a new entry under Disk drives of Device Manager, you

3. “Write Signature and Upgrade Disk Wizard” windows will show up and click “Next”. Step 44. Write a signature to the new drive, click “Next”.Step 5

6. Select the new “Unallocated” disk, and then right click to choose “Create partition”.Step 77. Follow the onscreen instruction to partition and full

CONTENTSINTRODUCING FIREWIRE/3ERUSOLCNESUPERSPEED 0.3BSU3ediuG siht tuobA3stnemeriuqeR metsyS4stnetnoC egakcaP4snoituacerP ytefaS6CISAB ERAWDRAH7 NOIT

Introducing IEEE 1394B FireWire/SuperSpeed USB3.0 2.5" Hard Drive Enclosure-PHR-S250U3BThank you for choosing the PHR-S250U3B portable IEEE 1394B

Package ContentsThe PHR-S250U3B portable IEEE 1394B FireWire/SuperSpeed USB3.0 2.5" Hard Drive Enclosure package includes the following software

ON TRANSPORTATIONSave the packing materials as you may need to repack and transport theunit at a later date.Always remove the disc before moving the u

Hardware BasicPrecaution:1) Please connect the enclosure directly to your computer.2) Please make sure your hand is dry and remove static from you

Hardware Installation1. Unscrew to loosen the Enclosure Back Panel.2. Remove the Back Panel from the Enclosure.3. Use both thumbs to push the Bottom T

4. Align the pins on the hard drive to the 22PIN SATA connector, and push the drive in completely.5. (a) Seat the Circuit Board and hard drive on

7. Put the Back Panel back to the Enclosure. 8. Secure the Back Panel with 2 screws (3mm in diameter) from each side.9. Connect the Enclosure directly